#1
Hey,

I've done a bit of searching, and was planning out the circuit to build my own, but though I'd check if there was something out there already.

Basically, I'm looking to have a pedal that has two loops for pedals, and two outputs for different amps. When loop one is engaged, I want amp one output to be engaged. The same for the second loop and output.

This is so I don't have to press two buttons, one to switch loop, and one to switch amp.
#2
i dont know if you know him but Dano (beavisaudio) has a crapload of circuits with loops and ABY ideas, which is essentially what youre looking for, if you want to do both with one switch, you might need a 4DPT.
Also, youll have more luck in GB&C with this
hope it helps
btw: this is his site:http://www.beavisaudio.com/
#3
Quote by Leon987
i dont know if you know him but Dano (beavisaudio) has a crapload of circuits with loops and ABY ideas, which is essentially what youre looking for, if you want to do both with one switch, you might need a 4DPT.
Also, youll have more luck in GB&C with this
hope it helps
btw: this is his site:http://www.beavisaudio.com/


I don't know him, I know very few people, infact I'll check out his site to see what he has though. And I was just looking to see if there was a commercial option before I go building, hence the section.

http://upload.wikimedia.org/wikipedia/commons/e/ec/DPDT-symbol.svg

And that's a DPDT, assuming the first leg was loop one and the third leg was amp one, that would work, wouldn't it?