#1
As I understand, all it takes a screw driver. But I need more specifics on it. I searched around the internet and found terribly written articles and the such. And seeing as how I really only trust UG I searched the lessons section. and now I'm here.

Im using some regular ernie ball super slinkys. Smallest gauge is 9, biggest is 32. I ordered some Skinny top heavy bottoms. The biggest gauge is 52, So I'm assuming ima need to adjust my truss rod. Theres just some specifics I rather not find out by experience cuz i really dont want to break my neck doin somethin stupid.

Do you adjust the rod after you put the strings on? (otherwise, I dont know if I could see where its bending)
Not sure of directions to adjust it (tighten it. loosen it)
Thanks for any help guys.
"A guitar is your personality expressed through six strings"

"I'm cuddly bitch, deal with it"
#2
Quote by Todd Hart
Shooting your friends with a real gun is a definite faux pas.

Quote by mystical_1
Professor Plum in the Studio with a new Amp

Quote by snipelfritz
If only I were the only one at home right now. I don't need my parents asking who Mr. Wiggles is.
#3
ah thanks. seemed like it shoulda been on this board though
"A guitar is your personality expressed through six strings"

"I'm cuddly bitch, deal with it"