#1
Hey guys,

First off this is NOT from a build i have posted on.

This is from my first build. So i have the fingerboard on the neck and ready to route a cavity for the nut. I have one problem:



If i route exactly i will have to cut those two little corners off and if i dont it will be tricky to get into the slot without getting the corners off.

Here's the nut i am using:

Can you tell me how i should install this?

Thanks!!
#2
I thought you meant "vagina or dick", not literally "slot or nut". now i regret clicking on this thread.
#3
This may sound kind of barbaric at first, but done properly it can give a really neat finish.

Chisel it out. Find a very fine/small but sharp chisel and carefully shave the wood away.

Hope this helps

Gear:
-Custom Frankenstrat (Now in bits pending a home-made Charvel So-Cal mod)
-Boss ME-25 (Modded with gaffer tape and blu-tack)


Quote by Xiaoxi
Modes and scales are dumb and useless. Stop learning them. No, seriously.
#4
Quote by ewashbrook
This may sound kind of barbaric at first, but done properly it can give a really neat finish.

Chisel it out. Find a very fine/small but sharp chisel and carefully shave the wood away.

Hope this helps


that sounds a little sketchy. what im kinda asking is, is it ok to cut the corners of the fingerboard?