#1
I just put on a Mighty Mite roller bridge, new strings, and a new nut on my les paul. It started to buzz really bad (b4 I put the new strings and nut on.) with out freting any notes. Just an open pluck and it will buzz. I thought it was the strings, so I got new ones, and it didn't work. Then I got a new nut, and that didn't work. The strings are no where near the frets but it buzzez realy bad. I really need your help.
#2
did you set the neck relief with the truss rod on the new neck?
2002 PRS CE22
2013 G&L ASAT Deluxe
2009 Epiphone G-400 (SH-4)
Marshall JCM2000 DSL100
Krank 1980 Jr 20watt
Krank Rev 4x12 (eminence V12)
GFS Greenie/Digitech Bad Monkey
Morley Bad Horsie 2
MXR Smart Gate
#4
the nut may be sitting too low then, can you compare the old nut to see if this is the case?

If it is you may need to shim the nut a little.
2002 PRS CE22
2013 G&L ASAT Deluxe
2009 Epiphone G-400 (SH-4)
Marshall JCM2000 DSL100
Krank 1980 Jr 20watt
Krank Rev 4x12 (eminence V12)
GFS Greenie/Digitech Bad Monkey
Morley Bad Horsie 2
MXR Smart Gate
#6
Without actualy seeing it I'm not certain. You might want to take it to a guitar tech/Luthier and have them take a look at it for you. most will do it for free and tell you what is wrong.
2002 PRS CE22
2013 G&L ASAT Deluxe
2009 Epiphone G-400 (SH-4)
Marshall JCM2000 DSL100
Krank 1980 Jr 20watt
Krank Rev 4x12 (eminence V12)
GFS Greenie/Digitech Bad Monkey
Morley Bad Horsie 2
MXR Smart Gate
#7
I would just get it checked out in person.
Quote by GuitarGod_92
when I die of a brain aneurysm I want it on record that its the film threads fault

Quote by GuitarGod_92
Movies are all bad every last one of them

Quote by yope
Fungus has a right to exist. It's a valid life form.