I'm trying to remove the black backing behind the grille and just have the metal part there so I can see the tubes. I have two questions about this though;

1. The Peavey logo changes colors according to channel. Behind it is a circuit board and a wire running from the power from the amp is going to this circuit board and it's soldered on there. Is it safe to just clip the wire so I can remove it, or will that have a negative effect on the amps inner workings?

2. The grille will have a small square in it from where the logo was. Is there any place to buy a Peavey logo to replace it so it doesn't have that open square? Peavey/eBay had nothing.

Thanks guys
Yes you can just clip the wires, but make sure you crimp the ends to avoid any kind of arcing
2002 PRS CE22
2013 G&L ASAT Deluxe
2009 Epiphone G-400 (SH-4)
Marshall JCM2000 DSL100
Krank 1980 Jr 20watt
Krank Rev 4x12 (eminence V12)
GFS Greenie/Digitech Bad Monkey
Morley Bad Horsie 2
MXR Smart Gate