#1
I've just bought a SD hot rail (STHR1B) for my tele & I'm thinking of capping/splitting the coil with a push/pull pot as I don't wanna lose the classics trebly tele SC bridge sound.

I've got a wiring diagram straight off the SD site -
[forbidden link]
Would this be the way people would recommend? I'm just slightly confused after looking into this on various forums and reading tapping/splitting/parallel/serial/hippopotamus.... My mind doesn't compute!
#3
Quote by booksofalbion
I think you want tapping/splitting, forget about parallel/serial and any other stuff.
I you were thinking of doing this (because your link doesn't show) I would recommend it:

http://www.seymourduncan.com/support/wiring-diagrams/schematics.php?schematic=tele_1hum_1sing_pushpull

Maybe someone else could give you more advice.


Cheers, that's much the same as the details I tried posting- available from this page

http://www.seymourduncan.com/products/electric/telecaster/high-output/hot_rails_for_t/