#1
(Invalid img)

I have noticed that the bridge and the part that holds the string they don't sit level with the guitar frame . you can see in the pic the metal spikes they should be inside the frame with the metal flat resting on the frame - on the other side they sit level . Just wondering if this will cause problems or anything i should be worried about .
#3
It looks like the studs are pulling out of your guitar.

Is it a new guitar? if so send it back.

It is a pretty easy fix though.
Remove them completely from the guitar.
Put a small amount of epoxy in the hole and gently tap them back in with a rubber mallet. You can use a regular hammer, but use a small block of wood/plastic to put over the tops before you tap them.
2002 PRS CE22
2013 G&L ASAT Deluxe
2009 Epiphone G-400 (SH-4)
Marshall JCM2000 DSL100
Krank 1980 Jr 20watt
Krank Rev 4x12 (eminence V12)
GFS Greenie/Digitech Bad Monkey
Morley Bad Horsie 2
MXR Smart Gate
#4
Quote by Robbgnarly
It looks like the studs are pulling out of your guitar.

Is it a new guitar? if so send it back.

It is a pretty easy fix though.
Remove them completely from the guitar.
Put a small amount of epoxy in the hole and gently tap them back in with a rubber mallet. You can use a regular hammer, but use a small block of wood/plastic to put over the tops before you tap them.

i cant send it back , I thought it might have been a badly made frame half of the other side is flush on the frame and the other half in the pic is up .
#5
Quote by dazzzer30
i cant send it back , I thought it might have been a badly made frame half of the other side is flush on the frame and the other half in the pic is up .
Well like I said it is an easy fix
2002 PRS CE22
2013 G&L ASAT Deluxe
2009 Epiphone G-400 (SH-4)
Marshall JCM2000 DSL100
Krank 1980 Jr 20watt
Krank Rev 4x12 (eminence V12)
GFS Greenie/Digitech Bad Monkey
Morley Bad Horsie 2
MXR Smart Gate