#1
Looking for some advice

My Randall RT100 amp keeps blowing the main fuse every time I take it off of standby. I replaced the fuses (the main one and the fuse for the 1st pair of 6L6's) and checked the tubes. It has burned two more since then. Any ideas on what could be wrong?
#3
I took them out and inspected them by laying them horizontal and in the light so I could see if anything was amiss. The last one of the right (facing the amp) was ruined. A piece of material was rolling around inside of it. I had a spare matched set in my gear stash so I installed a replacement for the broke one and the one next to it.
#4
Did you replace all f the power tubes?

There is always a chance it damaged part of the circuitry when it shit.

Pull your power tubes and see if the fuse still blows.
Quote by DeathByDestroyr
See, it's important that people clarify when they say "metal", because I pretty much always assume they are a Cannibal Corpse fanboi.
#6
Quote by LycoWarrior859
one by one or just pull all four power tubes and turn it on?


All.
Quote by DeathByDestroyr
See, it's important that people clarify when they say "metal", because I pretty much always assume they are a Cannibal Corpse fanboi.
#7
all of them.
2002 PRS CE22
2013 G&L ASAT Deluxe
2009 Epiphone G-400 (SH-4)
Marshall JCM2000 DSL100
Krank 1980 Jr 20watt
Krank Rev 4x12 (eminence V12)
GFS Greenie/Digitech Bad Monkey
Morley Bad Horsie 2
MXR Smart Gate
#9
Take it to a tech.
2002 PRS CE22
2013 G&L ASAT Deluxe
2009 Epiphone G-400 (SH-4)
Marshall JCM2000 DSL100
Krank 1980 Jr 20watt
Krank Rev 4x12 (eminence V12)
GFS Greenie/Digitech Bad Monkey
Morley Bad Horsie 2
MXR Smart Gate