#1
I'm so sorry if this is the stupidest/dumbest question ever asked, BUT, how do I set up my Marshall head and cab? I've linked some pictures to help. I basically don't know what wires go where. I'm using british mains which have 230volts. Its second hand, so I don't have a manual to assist. Thanks



#2
keep the switch on MONO. run a SPEAKER cable from the 16 ohm output on the back of the amp into the 16 ohm input on the cabinet (the one on the right)
#4
Quote by adambauman31
run a SPEAKER cable (...)

+3.1415

Just to be clearer, don't use an instrument cable to connect the head to the cab. You really need to use speaker cable for that, or you may end up with a pretty expensive repair in your hands.
Squier "VMC" Stratocaster
PRS SE Singlecut
tc electronic polytune
CMAT MODS Signa Drive
Blakemore Effects Deus Ex Machina
DIY gaussmarkov Dr. Boogey
EHX Small Clone
Mooer ShimVerb
DIY Beavis Devolt
T-REX Fuel Tank Chameleon
Ampeg GVT52-112
#6
Absurd picture size, by the way. And congrats on the new gear day.
Ceci n'est pas une signature.
#7
Quote by Basti95
Wrong cable mate!! Changeitchangeitchangeit



Actually, the cable that's connected to the head in the picture is adequate.
The picture even shows that the cable says "Professional Audio Line Cable (...) for Speaker".
Squier "VMC" Stratocaster
PRS SE Singlecut
tc electronic polytune
CMAT MODS Signa Drive
Blakemore Effects Deus Ex Machina
DIY gaussmarkov Dr. Boogey
EHX Small Clone
Mooer ShimVerb
DIY Beavis Devolt
T-REX Fuel Tank Chameleon
Ampeg GVT52-112