#1
I have a Peavey vk 112 and input one is broken, I want to fix it no matter what but is there a difference between the two and how would I fix it? Thanks.
#2
Just get a new jack and solder it into place.

Should be basically the same as this:
http://www.smallbearelec.com/servlet/Detail?no=798
Last edited by Invader Jim at Feb 2, 2014,
#4
Quote by 457undead
How would I open up the amp to do that?

It would be best to take it to a tech. That is a PCB mounted jack and if your not careful with a soldering gun you can lift PCB traces and do a lot of harm to the amp.
2002 PRS CE22
2013 G&L ASAT Deluxe
2009 Epiphone G-400 (SH-4)
Marshall JCM2000 DSL100
Krank 1980 Jr 20watt
Krank Rev 4x12 (eminence V12)
GFS Greenie/Digitech Bad Monkey
Morley Bad Horsie 2
MXR Smart Gate
#6
One is low gain and the other is high gain.

The first input is for most guitars and is roughly 10 dB louder than the #2 low gain input. The #2 input is meant for exceptionally high output instruments that could distort in the #1 high gain jack.
#7
I'm using a stock Mexican fender, so I believe that falls under the first input category. Doe's that mean that its necessary to fix the first input?
#8
Quote by 457undead
I'm using a stock Mexican fender, so I believe that falls under the first input category. Doe's that mean that its necessary to fix the first input?

If you want to, it would probably cost you $50-$75 to have a shop do it
2002 PRS CE22
2013 G&L ASAT Deluxe
2009 Epiphone G-400 (SH-4)
Marshall JCM2000 DSL100
Krank 1980 Jr 20watt
Krank Rev 4x12 (eminence V12)
GFS Greenie/Digitech Bad Monkey
Morley Bad Horsie 2
MXR Smart Gate