#1
I'm looking to perform a pickup/wiring upgrade on one of my guitars. It currently has a HSS pickup configuration with 1 volume and 1 tone. I've done upgrades and wiring mods before, but always from diagrams found elsewhere. This is my first time having to create what I want from scratch. I was hoping one of the Gurus here, might be able to advise me.

The pickups I've selected are Iron Gears.

Smoke Stack II - Neck
Smoke Stack II - Middle
Hot Slag - Bridge

These pickups (including the single coils) can be coil-tapped, which is a feature I'd like. I'm not too fussed about individual pickups, just all 3 pickups to be tapped at the same time, off the same switch. I think this can be achieved with a 3PDT switch.

I've spent the last hour or so looking over diagrams from various places and I think I've come up with the correct schematic.

Here it is:



I think that's right, but I was hoping for someone with a little more experience than me to cast a quick eye over it so I can be sure.

Thanks a lot all!
"Man, you can shred as much as you f**kin' want, but if you can't make my ass move, then f**k off!" - Dave Grohl.
#3
Quote by Invader Jim
Looks good to me, man.


The highest of praises!

Thanks Jim!
"Man, you can shred as much as you f**kin' want, but if you can't make my ass move, then f**k off!" - Dave Grohl.