#1
Hey everyone my guitar is set up from the factory like this:
1. Bridge Humbucker (series)
2. Bridge and neck(parallel)
3. Bridge Humbucker + Neck Humbucker series
4. Neck Humbucker (parallel)
5. Neck Humbucker (series).

I have found how to wire like this:
1. Bridge Humbucker (series)
2. Bridge Humbucker (parallel)
3. Bridge Humbucker + Neck Humbucker series
4. Neck Humbucker (parallel)
5. Neck Humbucker (series)

But am not sure how to get position 2 to include the bridge and neck hum bucker in parallel.

Any where I could find a wiring diagram for this?
#3
Thanks will, that was the site I was looking at already though. I can't work out how to make position 2 the neck bridge and hum bucker in parallel.