#1
I need some advice.

So I've got my pedal board set up figured out, but I've realized that there are alot of buttons to push just to get the overdriven sound I want (my amp's gain channel, Rat II, and TS9DX). I only have one amp that has two inputs (Bugera V22). Is it possible to have two lines set up on my board and each go into my amp's inputs or is there a simpler way to activate the TS9DX and Rat II at the same time?
#2
http://www.loop-master.com/looper-battery-version-p-200.html

Cable from Send-ts9-rat-return. Guitar goes into input. Keep both pedals on at the same time if that's how you always use it.
Charvel So-Cal (SH6TB/N, killswitch), Jackson RR5FR (TB6/Jazz, Drop C). Joyo pxl pro.
Loop1=Crybaby from hell, Boss PS-5, Seymour Duncan 805 or Green Rhino, EQD Hoof or Earthbound Audio Super Collider. Loop 1 into ISP Decimator II.
Loop 2 (FX loop)-Line6 M9, TC Spark Mini. Loop 2 into mxr 10band. All into a Peavey Triple XXX 212, Ibanez IL15.
#3
I had a similar problem, I got an A/B pedal and a Y-cable. This won't work if you need to change channels on your amp too though.
RG351DX - Bridge Dragonfire Screamer, Mid+Neck Fender Hot Noiseless
Peavey Valveking 112 - Eminence GB128
AMT E1 > Joyo AC Tone > Dan'o EQ > Shimverb > Digidelay