#1
Hello everyone. To everyone who has installed a bigsby on their tele before, I need some help! So far everything's been going ok and I've screwed in the bridge plate. I am now up to the part where you drill the large holes for the bridge bushings. In the instructions, I need to use a 9mm drill bit to do this. However, I only have an 8mm and a 10mm. The 8 is too small and the bushings wont fit inside the hole. Presumably the 10 will work but I'm wondering: will this make the bushings too loose?! Has anyone else used a different sized drill bit to do this before? Any help MUCH APPRECIATED
#3
^+1

get a BRAD-POINT bit so it does not wander around and your holes are correct

TS you should have done your homework
2002 PRS CE22
2013 G&L ASAT Deluxe
2009 Epiphone G-400 (SH-4)
Marshall JCM2000 DSL100
Krank 1980 Jr 20watt
Krank Rev 4x12 (eminence V12)
GFS Greenie/Digitech Bad Monkey
Morley Bad Horsie 2
MXR Smart Gate