#1
This may be painfully obvious, but I can't think of a way to do it for some reason.
Basically, I have a SD P-Rails in the neck position of one of my guitars and I'd like to be able to split it, then choose which coil with a pair of push/pulls (e.g. split on the volume, coil select on the tone).

Is this possible, or would I have to add in a mini toggle (and drill a hole in the front of the guitar )?

Thanks!
#2
This should do it.



The first switch is an "enable" that only lets you split the coils when the push-pull is pulled up/out/whatever. The second switch selects which coil is active; pull the push-pull up and the top coil is active, down and the lower coil is active. With a center-off toggle switch for the coil split, the "enable" switch wouldn't be needed.

It took me way too long to figure this out . Haven't done this in years...
Last edited by Invader Jim at Jul 4, 2016,