#1
Hello all,

I have an SG that I'm refinishing, and have the body sanded down. I have some old screw holes from a Bigsby that used to be on it as well as the stop bar holes that I'd like to patch before I start the dye, what should I use to patch these?
#2
I use a short plug that goes just below flush with the top of the hole and epoxy. You could do the whole thing with epoxy, but also adding a plug saves money.
Tony Done

http://www.soundclick.com/bands/default.cfm?bandID=784456
http://www.flickr.com/photos/done_family/