#1
I own an ESP KH-202.

The bridge is sunk into the cavity and adjusting the springs does nothing. Do I need to remove one of the springs? (there are three)
#2
linuxesp

Potentially. What guage strings are you using and what tuning?

Adjusting the springs should move things a bit unless your answers to the above questions are a bit extreme.
Guitars:
Jackson Kelly KE3 - MIJ (Distortion/Jazz)
Jackson DKMGT Dinky (EMG 81/85)
ESP E-II Eclipse Custom (JB/'59)
ESP LTD EC-1001FR (EMG 81/60)
Fender MIM Strat

Amps:
Mesa/Boogie Dual Rectifier Roadster 212
Laney IronHeart IRT-Studio
Peavey Vypyr 30
Peavey ReValver Amp Sims
TOOOO many T.C. Electronic Pedals. . .
#4
I use 10s in Eb with 3 springs and it works just fine.

Maybe some pics to see what you are doing?

Is this a new problem? What changed?
Guitars:
Jackson Kelly KE3 - MIJ (Distortion/Jazz)
Jackson DKMGT Dinky (EMG 81/85)
ESP E-II Eclipse Custom (JB/'59)
ESP LTD EC-1001FR (EMG 81/60)
Fender MIM Strat

Amps:
Mesa/Boogie Dual Rectifier Roadster 212
Laney IronHeart IRT-Studio
Peavey Vypyr 30
Peavey ReValver Amp Sims
TOOOO many T.C. Electronic Pedals. . .
#5
Been like this since day one.
I'll take pics tomorrow. Long work day.

Looking back, I should gotten an M10
#6
Loosen the two screws holding spring claw to the guitar until the Floyd is level and strings are in tune. You shouldn't need to go down to two springs with 10's.
Last edited by risingforce1 at May 30, 2017,
#8
Update:

The springs were in a triangle type shape/formation. I set the springs so they are aligned with the neck. I removed the center spring and began tuning and adjusting the springs, I learned that third string is needed. LOL

So far, I am getting a level bridge and strings are staying in tune. I took a break after 2 (The B and low e strings - e standard tuning) popped out LOL.

Thank you both. I am still getting used to the double locking tremolo system.
I will share pics asap.