#1
I have a Peavey TransTube 112 and was wondering if I could hook it up to a cab, say a Peavey XXX cab or a Peavey 6505 cab. Would i have to rewire something or just plug them into eachother?
#2
If the ohms match, you're fine.
I'm not very active here on UG currently.
I'm a retired Supermod off to the greener pastures of the real world.
#4
How many speakers are these cabs?

Even better, what are the individual speaker ohms?
I'm not very active here on UG currently.
I'm a retired Supermod off to the greener pastures of the real world.
#6
^Then I'm guessing there are 4 4 ohm speakers in series...

How many ohms is the transtube?
I'm not very active here on UG currently.
I'm a retired Supermod off to the greener pastures of the real world.
#7
Transtube 1 speaker
80 Watts RMS into 8 Ohms
100 Watts RMS into 4 Ohms
Last edited by dead_shall_rise at May 28, 2006,
#8
^And how many speakers?
I'm not very active here on UG currently.
I'm a retired Supermod off to the greener pastures of the real world.