#1
I want to turn my Behringer GMX212 into a cab so I don't have to buy a new one right away when I buy my JCM2000 and so I can save a couple hundred bucks. I'd like to be able to do minimal modding so I can sell it off later. I think I can use the Slave In/Slave out inputs, but I'm not positive. Could anybody help me?
2005 Epiphone Les Paul Custom
Marshall JCM900 MKIII Master Volume head
Carvin G412T cabinet
Line 6 DL-4
Boss BF-3
Boss CS-3
Boss NS-2
Boss OD-20
Boss PH-2
Ibanez TS-7 (being modded soon!)
Last edited by Ambulance X at Jun 6, 2006,
#3
Could I convert it to a 2x12 then convert it back to a combo when I wanna sell it?
2005 Epiphone Les Paul Custom
Marshall JCM900 MKIII Master Volume head
Carvin G412T cabinet
Line 6 DL-4
Boss BF-3
Boss CS-3
Boss NS-2
Boss OD-20
Boss PH-2
Ibanez TS-7 (being modded soon!)
#4
if the Ohms match up then you'd just need a small speaker cable and an adapter to put a male 1/4"jack to another male 1/4" jack, then you'd be done really
Quote by TehJermie
you can get that toneblaster stack at the cost of your dignity.

Quote by silhouettica
fine, screw the cheese sandwich if you must...


#5
Woah, I'm lost. What I was going to do was just cut the wire between the speakers and the input jack and put a 1/4 female input jack at the end of the wire and hook my head into that. Is that how I'd need to do it?
2005 Epiphone Les Paul Custom
Marshall JCM900 MKIII Master Volume head
Carvin G412T cabinet
Line 6 DL-4
Boss BF-3
Boss CS-3
Boss NS-2
Boss OD-20
Boss PH-2
Ibanez TS-7 (being modded soon!)