#1
So i bought a nice Marshall 1960A 4x12.

I decided to split my cube 60 amp into a head/cabinet version.

The cabinet was successful and only took 5 minutes.

I built a nice black enclousure for the amp.

I just finished wiring speaker out jack and before i screwed the back on i decided to see if it all works.

I plugged everything in to the cube 60 speaker and amp comes on, the output is there, but none of the knobs on the front work. its like there all set at 10 i tihnk.
Same results with the Marshall cab.

Delay and Phaser are on and its driving me crazy.

I cant think of any way anything could have gone wrong.

Does anyone know anything?
#2
Sounds like you wired it so that it bypassed all the knobs. Check your wiring, basically.
Feel free to ignore my ranting.

Member of the Self-Taught Club.

A recent study shows that 8% of teenagers listen to nothing but music with guitars in it. Put this in your sig if you're one of the 92% who isn't a close-minded moron.
#3
The only thing i changed the wiring on is the Output and i just disconnected the speaker and wiried it to a 1/4 inch jack...how could thins have bypassed all the knobs?
#4
I can't think of something else you could do that'd have that effect...
Feel free to ignore my ranting.

Member of the Self-Taught Club.

A recent study shows that 8% of teenagers listen to nothing but music with guitars in it. Put this in your sig if you're one of the 92% who isn't a close-minded moron.
#6
Its the right ohmage.
I fixed it now, it was a loose connection inside, thanks for your time though