#1
well i was adjusting the bridge on my strat and i dropped the little allen wrench into one of the top vents on my ad30vt. my question is....will it cause any problems? i know it probably wont but i just wanna make sure because i can always take the back panel off and take it out. i just dont want to if it isnt necessary. god im pissed cause now i need to go get another damn allen wrench because im not done yet!!
My Rig
>MIM Fender Stratocaster and SX SJM-62
>various magicial noise boxes
>Peavey Classic 50 212

For the funk:
>Ibanez ATK300
>Acoustic B100
#2
Get that wrenchg out of there!!! it can cause dammage by shorting out your circut board.... bad bad thing, it ike bridging a wire between the positive and negative of a battary... fireworks.... not a GOOD IDEA maybe take it to a tech and have it taken apart and allen wrench removed
Mail Goes here.

Musician for 14 years. Been inactive on UG since 2007. My have times changed. It's good to be back.
#3
^uggghhhh your kidding right? dang i guess i could just do it myself. is ther a lot of stuff in there that i might mess up by taking off the back panel and just taking it out?
My Rig
>MIM Fender Stratocaster and SX SJM-62
>various magicial noise boxes
>Peavey Classic 50 212

For the funk:
>Ibanez ATK300
>Acoustic B100