#1
I need to add a led to my amp's channel switch pedal. one exists for the O/D switch, but none for the reverb. I would like to have a led for the reverb as well so i dont have to play to know if its on, it just looks bad. Here are some badly drawn schematis of the pedal in its current state:

The new led has to go on the left switch. Any ideas of how to go about doing this?
#5
I know what I'm doing, you need a DPDT footswitch, an LED, a 2.2k resistor, a 9v battery clip, and a 9v battery. And then you need to wire it like this...

These go to eleven...