#1
hey there guys i wanted to know how to make a minor truss rod adjustment on my guitar. there was a wiring problem and i gave it to my friend to fix but he left it in his car for like 3 nights in a row and the neck is a lil outta shape.

how would i go about fixing this without going \to a professional? i want to use this guitar for a show i have tonight but if i cant fix it i have others.

thanks again.
#2
How is it "out of shape?" Have you actually gaged the neck relief?
Hi, I'm Peter
#3
gaged? or do you mean gauged? i know the neck is warped because its happened before on my other guitar


i just want to know how to fix it. its bowing in btw
#4
guaged. First you have to figure out how much relief there is. Put a capo on the first fret. Hold down the low E string at the 19th fret. See how much distance there is between the top of the 8th fret and the bottom of the low E string. It should be about the width of a credit card. If it's more than that, tighten the truss rod by 1/8th a full turn and let it sit for a while then check it again.
Hi, I'm Peter
#5
How To Adjust The Truss Rod

1) Always make sure that you're in your desired perfect tuning pitch.
2) Measure your neck relief and see whether its proper. Fret the 1st fret low E and the 19th/20th fret where the neck meets the body and see the 8th fretwire. There should be a clearance of at least 0.3mm-0.5mm between the low E and the fretwire.
3) If the string lays dead on the fretboard/fretwires or below 0.3mm (0.2 i still ok IMO), then you'd need to loosen your truss rod. If the string is higher than 0.5mm, then you have to much neck relief, you need to tighten your truss rod.
4) Always tighten or loosen your truss rod in 1/4th of a turn or 1/8th of a turn each time, and let rest between each turn for about 10-20 minutes to let your neck adjust to its new settings.
5) Check your neck relief by performing step#2 again and see whether its proper. Also, make sure that you're still in your desired tuning and re-check every now and then if your tuning runs off.
6) After you've accomplish to let your neck relief to be at least in between 0.3mm and 0.5mm, again, let the neck rest.

Tips:
- You can get extra hands and use a feeler gauge to measure your 8th fretwire or just simply capo the 1st fret. This is for more accurate measurement.
- Important* If your action is too high, that may also be the cause of your neck relief being higher than it should, i suggest that you restore the low E action to its factory setting (normally 2mm-3mm above the 12th fretwire) and measure your neck relief.

Various adjusting tool. Left (Allen Key), Right (Barrel Wrench)


Helpful websites:
- http://projectguitar.com/tut/trussadjust.htm
- http://www.jemsite.com/tech/1setup.htm#step3
- http://www.fretnotguitarrepair.com/trussrods.htm


------------------------------------------ madpickin03®------------------------------------------
"Play with your ears" - Yngwie Malmsteen, Paul Gilbert
Thats what she said...
UGmusic