#1
I've read a couple of the threads on daisy chaining and have found out about it.

My question is about my power supply. I've got a regulated power supply that I can change the voltages of. I've set it to 9V and I'm using a daisy chain on 3 behringer pedals. The spec sheet says they consume about 30mA but the recommended power supply was about 300mA.

Basically, I forgot how much ampage my power supply has, but on the back of the plug it has:

Pri (which I assume is primary): 100-240V~50/60Hz 0.4A
Sec: 9V = 1.7A

Judging by the first value, I don't have enough current. But judging by the second, I should do. So I'm a little confused as to why it's not working. If it is the second value that's right, then my daisy chain's screwed right?

Cheers

Ray