#1
So i have a schematic...



and i want to know what the coil tap w/ the push/pull pot does...

What will the push/pull control in each position??
#2
when pushed it will use the whole humbucker
when pulled it the humbuckers will act like single coil pickups

unless i've read it wrong
Quote by bassmanjoe08
Dan

Don't stop being you <3


Quote by fatgoogle
I think after this relentless adding for the last 10 mins, that Dan is the coolest looking. Goddamn welsh people and my great etc etc etc etc etc granddad is welsh.
#3
ok thanks

so if its a volume pot that the push/pull, the volume will be the same but the sound will change just by pulling?

and will the push/pull affect all pickups or just one?
#4
not sure about the volume thing but it'll affect both humbuckers
Quote by bassmanjoe08
Dan

Don't stop being you <3


Quote by fatgoogle
I think after this relentless adding for the last 10 mins, that Dan is the coolest looking. Goddamn welsh people and my great etc etc etc etc etc granddad is welsh.
#5
same volume. it effects whichever one your switched too.

when you split it, itll only be one single coil, not two single coils.