#1
hello y'all, quick question. Well i just recently got Cubase SX however im not too good at stuff like this so im not sure how to get the sound from the Pod into Cubase. I have it on my pc alright as i can record via Audacity however id rather use Cubase but it doesnt register the sound when i am recording? so basically im getting no input signal

Help appreciated greatly
#2
You have to go to the devices bar, down to device setup, then in VST Audiobay you should be able to select your POD, that is if your computer already recognizes the POD and doesn't see it as new hardware
Quote by MeGaDeth2314
just stick something in the hole and wiggle it around until you feel something poking out then push it hard.



Quote by gallagher2006
I seriously cant begin to tell you how refreshing it is to get some briliiant help from this site for once!

Thats about me