#1
i have a cheap fender/ electric guitar, and the input jack is getting really loose.
i have the chord ductaped to the back of my guitar to make it work. and iv tryed
just about everything.
so is there anyway to fix this?
thax
Rap --- Greenday


"life floats in a moving stream and you have
to move with it or it leaves you."
#2
First of all, I'm going to assume that you actually mean the output jack. There should be a low profile nut around the jack. You can get a nut driver to fit it, but it should be easier (and cheaper if you already have the tool) to use pliers to grip it and tighten it down.

if it's been like that for a long time and you've been abusing it, the wiring could be damaged, (which would better explain why it doesn't work without the duct tape) in which case you'll need to remove the jack and solder the wires back on. It's easier than it sounds, but it's another tool to buy if you don't have one already.
#3
yeah the output is what i was talking about im not in my normal state at
the moment.
thax for the advice ill try it
Rap --- Greenday


"life floats in a moving stream and you have
to move with it or it leaves you."