#1
Hey, I have a randall 412 and I'm thinking about cutting it in half to make two 212s. I just want know how other people went about doing this and the steps you'd go through. I couldn't find a tutorial for this but if someone could make one or tell me what they did, like how to wire the speakers and all, I would appreicate it. Thanks alot! (also if there is a tutorial and i missed it, just tell me)
#2
just cut it in half. its easy.

wire it up later.
Call me "Shot".

ShotRod Guitar Works

Custom Hand-wired Amplifiers and Effect Pedals.

Est. 2007


Source to everything I say about Guitars, Pedals, and Amplifiers: I make them.


UG's Best DIY PedalBoard
#4
Well you would have to buy some wood to go on each 212 cab for the top or bottom, obviously. As for wiring wire it correctly to your amps speaker ohm outputs.
Last edited by DeadMansCurve at Oct 25, 2007,