#1
does anybody know any mods for the Marshall belt clip amps?
just wondering.

nothing specific, just any mods at all
#2
u have one?

i would just take the whole thing out, and put in a Ruby lol.
Call me "Shot".

ShotRod Guitar Works

Custom Hand-wired Amplifiers and Effect Pedals.

Est. 2007


Source to everything I say about Guitars, Pedals, and Amplifiers: I make them.


UG's Best DIY PedalBoard
#4
damn you guys! I want real mods!
like resistor changes and increasing the wattage

if I chnage the stock speaker (8ohm, 0.8 W) to a higher wattage, what do I do to the components to increase overall volume?
#5
uh.... feed more voltage??? lol.

i really would install a ruby in there.
Call me "Shot".

ShotRod Guitar Works

Custom Hand-wired Amplifiers and Effect Pedals.

Est. 2007


Source to everything I say about Guitars, Pedals, and Amplifiers: I make them.


UG's Best DIY PedalBoard
#6
well, I cant because I'm poor. I can only afford resistors and maybe an old speaker from a used alarm clock or something.
#7
The only thing you can do to increase the volume is get a new op-amp with higher gain, or change whichever resistors are limiting its gain for higher volume but possibly lower headroom. It's tough to tell what to mod if you don't have a schematic, though.