#1
Im getting new speakers for my valveking, and theres a switch on the back to switch from 8-16 ohms, but when i replaced the speakers how many ohms shoudl they be? And what would happen if i got 8ohms.
Guitars-
Schecter S-1 Elite
Fender MIM Strat
Epiphone SG Faded
Epiphone Sheraton II

Amps-
Peavey Valveking 212

Pedals-
Dunlop CryBaby
Boss NS-2
Ibanez Tubescreamer TS9

CHECK OUT MY BAND AT http://www.myspace.com/noneofusalone
#2
don't put the switch off from 8 ohms if ya do.. It's a measure of resistance, and if ya had it on a wrong setting, you could end up either not getting any sound, or blowing the speaker or amp or both. I think, anyways
The rig:
Gibson SG faded special -> Marshall MG 50/100 (working on a valve amp)
Backup: Vintage AV1
Newcastle United
#3
I would try to go with whats in there. But you can wire 2 speakers in different ways to get different ohms.