#1
Hi, I purchased a guitar today, and I noticed the bridge isn't flush with the body of the guitar. The front end(towards the neck) is but the near is slightly raised. Is this normal or should I tighten the screws that pull the springs under the back panel?
The Setup:
Fender Standard Stratocaster
Crate GFX-30
Vox AD50VT
#3
Quote by DarkDragon786
Hi, I purchased a guitar today, and I noticed the bridge isn't flush with the body of the guitar. The front end(towards the neck) is but the near is slightly raised. Is this normal or should I tighten the screws that pull the springs under the back panel?


Yes, you should tighten them. Tune the guitr down a little first to release string tension, then tighten screws (just a little), and tune back up. If needed, repeat until you get the desired result.
#4
Quote by petrina_678
wad guitar ... what bridge....

bring it for a proper set up

Fender Standard Stratocaster. I'm guessing it's the standard bridge.
The Setup:
Fender Standard Stratocaster
Crate GFX-30
Vox AD50VT