#1
k so ive started making a start ive got the body cut out and ready to start routing 1 question though how would i rout it so that it doesent need a scratchplate like how the electronics are on a les paul?
thanks in advance
#2
Rout the control cavity on the back of the guitar, rather than on the front. It will still need a covering, but it won't show
Quote by Liberation
Every time I see your avatar I want to slit your neck with a butterknife. Goddamn Pingu.
#3
Quote by loonyguitarist
Rout the control cavity on the back of the guitar, rather than on the front. It will still need a covering, but it won't show


+1
Listen to him
Out here you've gotta know where your towel is!
#6
Quote by rancidryan
yeah but i was wondering how do i ut the holes in for the wires to get there?

Ah, ok. You mean between the control cavity and the pickup holes? You can use a drill for that. If you can't get a good angle, then you can maybe get a long drill bit and drill through the hole where you will have your jack/guitar cable and then through to the pickups.
Quote by Liberation
Every time I see your avatar I want to slit your neck with a butterknife. Goddamn Pingu.
#8
yea, a long drill bit is the way to go if you don't have a cap. you can pick these up at lowes.