#1
Im running a 5150 II And for the past 20 mins or so Iv been trying to get it to run through the loop channel. I want to get the TU to work as a mute(and tune of course). And for the N2 To noise reduct. It feels like iv tried every combination of input, send out put ect...... Tried running it through the pre amp slot on back which i have no idea what it does but didnt work. Read the instructions of course which dont help for **** lol

Anyway i could use some help
Esp Ltd Viper 400
Ibanez RGT6EXFX
Peavey 5150 II
Randall Jag Cab
Mesa Boogie Oversized Cab
Maxon OD808
Boss Pedals
Last edited by ComradeRose at Feb 27, 2008,
#2
Guitar - TU - amp input - Preamp out - NS2 - power amp in. That should work. Also, it's better to have the tuner before the preamp - thus it doesn't get a distorted signal, but rather a clean one.
Quote by Lunchbox362
This thread if fail in almost every way imaniganable.
#3
.i should only have to plug my guitar into the amp imput if its running through the loop chann though right? Not any pedals?

Also the N2 has a out,in, send,return
which slots. so many lool
Esp Ltd Viper 400
Ibanez RGT6EXFX
Peavey 5150 II
Randall Jag Cab
Mesa Boogie Oversized Cab
Maxon OD808
Boss Pedals