#1
Anyone have any instructions on how to disassemble a wah enclosure? I want to take the rocker pedal of to clean, and maybe paint it.

thanks
#2
which wah?

crybabies looks to me that u can take it apart by taking off two small nuts from the inside facing upwards. those hold down the little strap holding it in place i think.
Call me "Shot".

ShotRod Guitar Works

Custom Hand-wired Amplifiers and Effect Pedals.

Est. 2007


Source to everything I say about Guitars, Pedals, and Amplifiers: I make them.


UG's Best DIY PedalBoard
#3
If it's typical wah enclosure like a Vox or Crybaby you'll need to pop out the pin/axle part. The flat spring only adjusts the tension, doesn't hold it in place.
#4
Thanks Led and EC...

Led: Would I just do this with a punch and drift the axle/pin out? If done properly it shouldn't damage anything should it?
#7
Quote by cj223
Thanks Led and EC...

Led: Would I just do this with a punch and drift the axle/pin out? If done properly it shouldn't damage anything should it?


Yeah pretty much. I just used a hammer and nail... dull the end of it a bit! You'd need some serious strength to do any damage