#1
I have a Schecter S1 Elite, with a coil split/tap operated by a push/pull tone knob. I need a wiring diagram for it, as I have some new pickups to fit. Anyone got one?
#2
Go to the Seymour Duncan forums, and under support go to wiring diagrams. It'll be there.


Essentially, the push pull has 6 lugs, 2 columns of three. The two upper lugs are going to ground, the two bottom don't have any connections. The red and white wires (if it's a Duncan going in) of each pickup will go on the opposite middle lugs.

This way when you pull up on the pot, the red/white conductors will be grounded, shorting a coil.