#1
ok...so if I wanted to make a switch to change how a overdrive pedal clips how would I do that? I want it to change to 2 leds when the switch is flipped. heres a schematic to help show you what i mean.
Quote by Peradactyl
alright, off topic but how do i make forum posts



Quote by The_Paranoia
a4lrocker is an offical thread legend.
#3
Get a DPDT toggle then wire it like this.



Blue wire is coming from C2, Green wire from SW1. Then Red to D1, Orange to D2 (ground those normally). Then yellow goes to your first LED which is the same polarity as D1, and purple goes to your second LED which is the same polarity as D2 (ground these as well). That should do it.
Fender MIM Stratocaster
Ibanez TS-9 Tube Screamer
Fulltone OCD
Dallas-Arbiter Wah Baby
Home-Built Germanium Fuzz Face
MXR Carbon Copy Analog Delay
2 Fender Blues Juniors
#4
Quote by a4lrocker
ok...so if I wanted to make a switch to change how a overdrive pedal clips how would I do that? I want it to change to 2 leds when the switch is flipped. heres a schematic to help show you what i mean.

1 - The picture says swap one. We'll swap the LEFT one.
2 - We will add two new parts: a SPDT switch and a 1N914 diode.
3 - The cathode of the left 1N34a is connected to ground. Leave it there.
4 - Break the connection to the anode of the left 1N34a to the top rail.
5 - Connect the pole of a SPDT switch to top rail.
6 - Connect one throw of the SPDT switch to the anode of the left 1N34a.
7 - Connect the other throw of the SPDT switch to the anode of the of the new 1N914.
8 - Connect the cathode of the new 1N914 to ground.
9 - ?????????
10 - PROFIT!!!
Meadows
Quote by Jackal58
I release my inner liberal every morning when I take a shit.
Quote by SK8RDUDE411
I wont be like those jerks who dedicate their beliefs to logic and reaosn.
#5
thanks a lot guys. im pretty sure i get it now.
Quote by Peradactyl
alright, off topic but how do i make forum posts



Quote by The_Paranoia
a4lrocker is an offical thread legend.