#1
I'm using this wiring setup for my guitar I'm putting together.

http://www.seymourduncan.com/support/wiring-diagrams/schematics.php?schematic=1lil1v1t5w3s

I want to put the coil split push pull pot in the tone position instead of the volume.

Am I right in assuming I just run the applicable wires exactly the same, but just move the push pull elements to the tone pot? Search bar didn't show much. I drew the schematic on paper that way and it seems like it would work, but I was hoping for some experienced advice on this one.

Thanks
82 Ibanez artist ar105
94 Fender MIJ 72 tele custom reissue
04 prs se soapbar singlecut
97 Simon & Patrick pro flame maple
05 Art & Lutherie cedar 12
Custom Strat

68 Fender Super Reverb
78 Traynor TS200
80's Roland Cube20