#1
ok i know theres a lot of killswitch threads, but i still have a question, is there a way to get rid of the popping noise you hear when you activate it?
#2
wire shielding and good wiring. as long as you do it well and right there shouldnt be a popping. unless the switch you are using makes a clicking noise. then the only way to stop it is to get rid of the piece that causes it to make the clicking itself. i would suggest just replacing it with a button. they ten to not click and lock in place.
#4
Quote by Invader Jim
...Or put a high-value resistor between the switch and Ground.


In paralell or series?