#1
I have a Fender MIM Strat, and i want to change the tuning pegs on it. But i cant find how to take the stock ones off. Could anyone help me figure out how to take them off.

-Garrett
#2
Undo the nut on top
我会关闭我的耳朵,和我的心; 我会变成一个石头
"I will close my ears and my heart and I will be a stone"
#3
haha alright, thats what i was thinking. thanks man.
one more thing. im going to put new tuning pegs on it. would i have to drill new holes?
#4
Quote by garrettmhaynes
haha alright, thats what i was thinking. thanks man.
one more thing. im going to put new tuning pegs on it. would i have to drill new holes?

Only if the new tuners are too large. More than likely, they may be too small (as in the case of trying to install retro tuners). You may need a conversion bushing that fills the gap. You can get these from a lot of the same sites that sell tuners.

Measure twice, cut once.
Sincerely, Chad.
Quote by LP Addict
LP doesnt have to stand for les paul.. it can stand for.... lesbian porn.
#5
Also, make sure your new tuners use the same alignment method (Either a small offset screw, or a pin ).
我会关闭我的耳朵,和我的心; 我会变成一个石头
"I will close my ears and my heart and I will be a stone"