#1
I was just wondering if it can be a cabinet to lets say a blackheart head, because it has a speaker jack not a hardwire thing. I just don't want to buy a separate cabinet it not needed...

Is it possible?
Jem 7dbk
Ibanez s540 custom
Ibanez RG570
Ibanez RG520
Ibanez Roadstar II RG410
Ibanez Destroyer II 80's
Schecter C-1 Blackjack
Gibson LP Studio Lite
Fender Start MIM
Kramer Sustainer
Jackson DKMG Dinky
Peavey XXX 40W
Vox DA5
#2
if the ohms match

EDIT: and the speaker voltage is higher than the head
05' G&L S-500
95' Godin LGX

96' Yamaha APX 6-A

Peavey Classic 30
Maxon OD808
#3
If the speaker has a 1/4" jack instead of 2 wires and push fit joints then yes you can. Remember to match ohmage as well.
...
#4
Quote by bartdevil_metal
If the speaker has a 1/4" jack instead of 2 wires and push fit joints then yes you can. Remember to match ohmage as well.


even if it didn't have a 1/4 jack could you just cut the wires and solder one on?
05' G&L S-500
95' Godin LGX

96' Yamaha APX 6-A

Peavey Classic 30
Maxon OD808
#5
Thanks for the comments, i will try this... i was just wondering if the speaker will work without anything powering them.
Jem 7dbk
Ibanez s540 custom
Ibanez RG570
Ibanez RG520
Ibanez Roadstar II RG410
Ibanez Destroyer II 80's
Schecter C-1 Blackjack
Gibson LP Studio Lite
Fender Start MIM
Kramer Sustainer
Jackson DKMG Dinky
Peavey XXX 40W
Vox DA5
#6
I use my Classic 30 as a cab for my Valve Junior. The classic 30 has a 16ohms speaker jack at the back
Ibanez RG570
USA Strat
Epi Les Paul

Peavey Classic 30
Epi Valve Jnr
Laney LV200
Boss ME50
Daddy O
DC Solid Metal
GNX 3000
#7
I actually used my C50's speakers as a cab for my friend's blackheart little giant.
You should be fine. Just make sure to match the ohms.
Call me Wes.
Gear:
Fender American Deluxe HSS Strat
Chicago Blues Box Roadhouse
Bad Cat Cougar 5
1957 Gibson GA-5
Ceriatone 18w TMB Combo
Hughes & Kettner Tube Factor
Various Ibanez TS9s
Weber MASS Attenuator