#1
i replaced the stock strings on my new guitar (PRS Paul Allender SE) with Elixir 0.010 to 0.046, and the distance between the strings and the frets has increased. I lowered the bridge a bit and am about to adjust the truss rod, should i be loosening it or tightening it? Theres fret buzz on the lower frets and the action seems to be a little high in the middle...but low on the higher frets.
#2
if its a PRS I wouldn't touch it myself.. get it looked at by someone who knows what they are doing.
Sharing is caring
Fuck the RIAA

- Gear -
ESP LTD MH-400
Epiphone Les Paul
Vox AD30VT
Zoom G2.1u
#3
u shouldn't of lowered the bridge. put the bridge back up and slightly tighten the truss rod and then tune to pitch and leave sit over night since the truss rod wont fully effect the neck till after a day.
then repeat if not satisfied
Last edited by selkies at May 8, 2008,
#4
oki dokie, ive put the bridge back...the action is a little higher than id like but its playable, ill bring it to the guitar dude he said hed adjust it for me if the strings changed the guitar.