#1
i dunno if this is the right place for this, so please direct me if im wrong

my tone knob is very loose, and rattles around alot. i was wondering, how do i tighten it, or take it off to tighten it??

thanks
STEAM: beachhhhhhhh

Quote by cornmancer
Please daddy, just for one hour.
#2
It should have a little screw that you can tigthen, if not, just push down on it, fender type knobs generally just have to pushed in. If its a screw, a little screwdriver or anything that can fit in the screw to tighten it, will do fine.
#3
thanks man, i just pushed and turned, and its tightened!

edit: no it hasnt how do i take it off, just pull?
STEAM: beachhhhhhhh

Quote by cornmancer
Please daddy, just for one hour.
#4
If it's the kind that doesn't need to be removed. Just glue it on or something lol. But if it's over the scratch plate, like strats, just push it on, or maybe blutac could help lol, idk.
My Gear
Guitars
Cort VX-2V
Basses
Stagg BC300
Amps
Marshall JCM900 4100 DR
Marshall 1965A
Hartke HA3500 Combo
#5
i just pulled it off, and the thing it was attached to fell inside, so i took the backplate off, then fixed it
STEAM: beachhhhhhhh

Quote by cornmancer
Please daddy, just for one hour.
#6
Quote by Hoodoo Child
i just pulled it off, and the thing it was attached to fell inside, so i took the backplate off, then fixed it

Lol, did you blutac it, cause imo it sounds like a good solution =P
My Gear
Guitars
Cort VX-2V
Basses
Stagg BC300
Amps
Marshall JCM900 4100 DR
Marshall 1965A
Hartke HA3500 Combo
#7
Quote by Jesstaa
Lol, did you blutac it, cause imo it sounds like a good solution =P



nahhh i just screwed the nut back on tighter.
STEAM: beachhhhhhhh

Quote by cornmancer
Please daddy, just for one hour.