#1
Well, I'm about to buy a electro harmonix holy stain, but I have some questions:
- shoud i put it in my effects loop or just in my amp because, there is a distortion pedal in it but also some effects?
- shoud i put it before or after my digitech death metal? what do you think is best?

grtz
Henis
#2
OD's/Distortions should be in front of the amp. And just take the Digitech out of the signal chain.
AMP:
5150 combo
GSP1101 + Tech 21 PE60

GUITARS:
ESP LTD M-255 w/ SD Full Shred
Kramer Vanguard w/ JE-1000 active preamp
Douglas WF-150sn w/ GFS "Hot Lead" set

EFFECTS:
Bos SD-1 (boost)
AMT DT-2

My Youtube Vids http://youtube.com/user/mogar
#3
Quote by mogar
OD's/Distortions should be in front of the amp. And just take the Digitech out of the signal chain.


out of the signal chain? you mean just don't use it?
#4
yup
AMP:
5150 combo
GSP1101 + Tech 21 PE60

GUITARS:
ESP LTD M-255 w/ SD Full Shred
Kramer Vanguard w/ JE-1000 active preamp
Douglas WF-150sn w/ GFS "Hot Lead" set

EFFECTS:
Bos SD-1 (boost)
AMT DT-2

My Youtube Vids http://youtube.com/user/mogar
#5
Quote by mogar
yup


ahn okey, that really doesn't solve anything but thanks anyway.
#6
it really depends what you are using it for. If you're running the amp on the clean channel then there'll be no problems using the other effects as well, and have the digitech distortion connected before the holy stain. If you don't put it in the FX loop and you're using a distorted channel on the amp, the amp will distort the effects. the Digitech pedal will also distort the effects if you put it after the holy stain.
Rig Winter 2017:

Fender Jazzmaster/Yamaha SG1000
Boss TU-3, DS-2, CS-3, EHX small stone, Danelectro delay
Laney VC30-112 with G12H30 speaker, or Session Rockette 30 for smaller gigs
Elixir Nanoweb 11-49 strings, Dunlop Jazz III XL picks
Shure SM57 mic in front of the amp