#1
ok... i want to hook up my

bridge pickup

to

volume knob

to

output hole (amp chord)

is this possible? if so could somone please tell me where i need to solder the wires
into the volume pot and to the output


Thanks again!
#2
How is this different than standard? Just switch to the bridge pickup and there you go.

I'm confused as to what you want.
Alvarez dreadnought
Gibson SG
EC-1000
Homemade Strat (seymour duncan classic stack p/ups)
Vox Tonelab (original desktop model) with full board footswitch
Vox AD50
Avatar V30 4x12 cab
#3
it would go black from pickup to bottom of volume pot white from pickup to side of volume pot and then black from output to bottom of volume pot white from output to side of voulme pot Its deffinitly possible im pretty sure thats how it should go
Quote by Jaymz_515
One of my friends was thrown into the sun by a teacher for speaking in the library.
#5
srry guys


i have 3 single coil pickups

and

1 volume knob
2 tone knobs

i want to use the bridge pickup with the volume knob