#1
I'm just installing the Dimarzio Tone zone into my flying V find thread here:

https://www.ultimate-guitar.com/forum/showthread.php?t=882524

However i've installed an extra switch to coil tap the Tone Zone and i can't formulate or find a diagram.

Basically i have a 2 humbucker setup. 1 Volume, 1 Tone, 1 3 way pickup selector and 1 3 way switch to coil tap the Tone Zone can somebody help me out?

Regards,
Mad
'05 Fender Speed Shop So-Cal Stratocaster
'95 Squier Standard Strat

OLP MM1
Washburn X200v Pro

Tanglewood TW145-SC
Yamaha C40

Orange Dark Terror + PPC212
Jet City JCA20H + JCA24S
#2
Will this do what you want? - you might need to do some work around the switch - as this diagram is a push pull pot, and I'm not sure what you have installed!

http://www.seymourduncan.com/support/wiring-diagrams/schematics.php?schematic=2h_1v_1t_3w_1pp

I assume you mean coil split, rather than coil tap, as Dimazario's website doesn't suggest that your pickup has a coil tap.

On the diagram above, both of the humbuckers are split - if your other humbucker isn't splitable (4 wires) then you just wire the hot to the switch, and the shield to ground. If it is a 4 wire pickup but you don't want to split it, just solder the white/red (actually see below) and tape them up.

I've just had a look at this too:

http://www.seymourduncan.com/support/wiring-diagrams/schematics.php?schematic=color_codes

You Dimazario will have a different colour code to the SD ones - you can translate it using that page - and you don't mention what your other pickup is - hope that helps!
#3
Quote by mark_wuk
Will this do what you want? - you might need to do some work around the switch - as this diagram is a push pull pot, and I'm not sure what you have installed!

http://www.seymourduncan.com/support/wiring-diagrams/schematics.php?schematic=2h_1v_1t_3w_1pp

I assume you mean coil split, rather than coil tap, as Dimazario's website doesn't suggest that your pickup has a coil tap.

On the diagram above, both of the humbuckers are split - if your other humbucker isn't splitable (4 wires) then you just wire the hot to the switch, and the shield to ground. If it is a 4 wire pickup but you don't want to split it, just solder the white/red (actually see below) and tape them up.

I've just had a look at this too:

http://www.seymourduncan.com/support/wiring-diagrams/schematics.php?schematic=color_codes

You Dimazario will have a different colour code to the SD ones - you can translate it using that page - and you don't mention what your other pickup is - hope that helps!


Thanks i did mean Coil Split my bad.

It's all installed and working now and was easier than i thought. I just used a combination of:

http://www.dimarzio.com//media/diagrams/4Conductor.pdf

and

http://www.seymourduncan.com/support/wiring-diagrams/schematics.php?schematic=2h_1v_1t_3w

and it sounds pretty immense!
'05 Fender Speed Shop So-Cal Stratocaster
'95 Squier Standard Strat

OLP MM1
Washburn X200v Pro

Tanglewood TW145-SC
Yamaha C40

Orange Dark Terror + PPC212
Jet City JCA20H + JCA24S