#1
Hi guys!

I was just wondering if I could connect my Carvin V3-head(with switchable load 4,8,16 ohms) to my marshall jmp 2x12" combos speakers. These are 15 ohms each, which will make a total of 7,5 right?


Will the 0,5 differnce in impedance fry my amp?


Thanks!
Last edited by Matsols at Jul 26, 2008,
#2
It should be fine, when current is running through them, the resistance will be a little higher. Usually 4 ohm speakers read about 3.6 when there is no current in them.
Just make sure the Marshalls can handle the power.