#1
My output jack on my guitar came loose, and I lost the parts that fell off as I hadn't noticed. I found a nut that fit it, but in order to get it tight around the jack, I had to remove a washer that had sorta teeth ( I don't know the correct term ) from the inner side of the jack plate, the side that's inside the actual guitar , the teeth on it were bent as well. I'm asking, is it safe to do this?
#2
umm if i were you i'd get a new jack... they're quite cheap anyway
Quote by Moggan13
Serjem is like a Bishops testicals: Swollen
ಠ_ಠ
IIIIfb * KARKOLI * ytIIII(mostly rock... a little funky, a little hard just the way you want it )
#4
^Thanks man. I wasn't too sure if it was a good solution, but I have a gig tomorrow, and I just need it until I can take it to a guitar shop to get it fixed proper. If it needs it.