#1
Due to the thread on the Valveking, I was wondering what you guys thought I should do to beef it up but still keep it tight...

My settings are:

Amp:
Gain: 7
Treble: 7
Mid:6
Bass:9

Pedal(Blues Driver):
Level: 5
Tone: 7
Gain: 5

Should I replace the speaker or tube? Yeah, it has only one pre-amp tube, haha. Thanks for any suggestions.
My Gear:
~~~~~~~~~~~~~
Guitars:
Gibson Explorer, Worn Cherry-

Amps:
Fender Roc Pro 1000 - 1 x 12 Combo, 100 watts, Hybrid


Effects:
Blues Driver Keeley Modded
#2
Nuttin'!?
My Gear:
~~~~~~~~~~~~~
Guitars:
Gibson Explorer, Worn Cherry-

Amps:
Fender Roc Pro 1000 - 1 x 12 Combo, 100 watts, Hybrid


Effects:
Blues Driver Keeley Modded
#3
You need less treble and bass, and more mids. Because if your EQ looks like this your audience (including you) looks like this

people seem to neglect the midrange. I'd say turn the mids up at least one extra notch.

Also if your amp has a tube preamp (does it?) you could reduce the amp gain a little, and set your pedal like this: (Boss BD-2, right?)

Level: experiment but keep it higher than the bypassed guitar signal
Tone: whatever you want
Gain: 0

This should work as a clean boost which will kick the preamp harder - this will only sound good if its an actual tube preamp though.
Rig Winter 2017:

Fender Jazzmaster/Yamaha SG1000
Boss TU-3, DS-2, CS-3, EHX small stone, Danelectro delay
Laney VC30-112 with G12H30 speaker, or Session Rockette 30 for smaller gigs
Elixir Nanoweb 11-49 strings, Dunlop Jazz III XL picks
Shure SM57 mic in front of the amp
#4
Oh okay...I thought the mids were pretty high. So should I drop one on both the treble and bass as well as up the mids one more? Thanks man...and it has one preamp tube.
My Gear:
~~~~~~~~~~~~~
Guitars:
Gibson Explorer, Worn Cherry-

Amps:
Fender Roc Pro 1000 - 1 x 12 Combo, 100 watts, Hybrid


Effects:
Blues Driver Keeley Modded