#1
So the killswitch thread doesn't say much about this, and I was wondering, which wires go to which positions on my 5-way pickups. My idea is to disconnect the wire(s) that connect to the second position on the selector. That way I could easily toggle with the lead pickup and still use the bridge one if I wanted to (almost never).
So heres a picture of the selector:


Heres some pictures of the pickups:




Thanks to anyone who can give even a little help.
My meh gear:
ESP LTD MH-400NT
Peavey Raptor Plus EXP
Digitech RP90
Digitech Bad Monkey
Electro-Harmonix Big Muff Pi (WTS)
Crate GT15 (SHIT)

GAS:
Peavey 6505 112 combo
MXR 10-band EQ
Ibanez TS-9
Boss HR-2
Compressor (open to suggestions)
#2
Bump. C'mon guys I already took off the pickguard and stuff and I wanna finish it today. Please?
My meh gear:
ESP LTD MH-400NT
Peavey Raptor Plus EXP
Digitech RP90
Digitech Bad Monkey
Electro-Harmonix Big Muff Pi (WTS)
Crate GT15 (SHIT)

GAS:
Peavey 6505 112 combo
MXR 10-band EQ
Ibanez TS-9
Boss HR-2
Compressor (open to suggestions)
#3
It's not that easy... you could do it in positions 1, 3, or 5, but 2 is hard.
Gear:
Schecter Hellraiser Deluxe
Boss DS-1
Crate GTD65

GAS List:
Mesa Boogie Dual Rectifier Roadster
#4
Ok, so I decided to take a chance and cut the white wire that was in between 2 other white wires. It now cuts off in the middle selector, the third.
My meh gear:
ESP LTD MH-400NT
Peavey Raptor Plus EXP
Digitech RP90
Digitech Bad Monkey
Electro-Harmonix Big Muff Pi (WTS)
Crate GT15 (SHIT)

GAS:
Peavey 6505 112 combo
MXR 10-band EQ
Ibanez TS-9
Boss HR-2
Compressor (open to suggestions)
#5
Quote by JungIe
Ok, so I decided to take a chance and cut the white wire that was in between 2 other white wires. It now cuts off in the middle selector, the third.


There ya go.
I was going to explain you how to do it for other positions, but looks like you already figured it out.
Gear:
Schecter Hellraiser Deluxe
Boss DS-1
Crate GTD65

GAS List:
Mesa Boogie Dual Rectifier Roadster