#1
For grounding the pick ups or Pots i should say, you just run the wire to the bridge stud, then just put the stud on over it?
Greg Bennett Ultramatic UM-3 sig.
Custom Greg Bennett Hollowbody UM-4 sig.
Greg Bennett Fastback FB-3
Greg Bennett ASDMCE Acoustic
Fender GC-12 Acoustic

Amps:

Line 6 Spider III 15amp
Line 6 Vetta II HD

Effects:
Digi-tech RP-150
#2
what? To ground a wire you solder it to the top of one of your pots.
Gibson SG Standard
Ibanez S2170FB
Peavey JSX
Marshall 1960A
TEXAS A&M
#3
I knot you solder it to the top of the tone. But that wire is fed to the stud of the tail piece? Im just wondering actually how it is done.
Greg Bennett Ultramatic UM-3 sig.
Custom Greg Bennett Hollowbody UM-4 sig.
Greg Bennett Fastback FB-3
Greg Bennett ASDMCE Acoustic
Fender GC-12 Acoustic

Amps:

Line 6 Spider III 15amp
Line 6 Vetta II HD

Effects:
Digi-tech RP-150
#4
oh, on mine there was a screw in the cavity that attached to the bridge, then the wire was wrapped around that.
Gibson SG Standard
Ibanez S2170FB
Peavey JSX
Marshall 1960A
TEXAS A&M